ProTapes Pro Glow-in-the-Dark Tape 1" x 10yds
Product Highlights
- Used to spike stages for placement of scenery.
- Used for marking exits in dark areas.
- Flexible vinyl backing is conformable and easy to cut to size.
- Used to mark light switches.
- Can be printed.
- Can be die cut to custom sizes and shapes.
- Lasts for up to ten hours.
Related Products
Pro® Glow has a non-radioactive chemical light source incorporated into a flexible vinyl film that glows in total darkness after exposure to artificial or natural light. The photoluminescent film light source is designed to absorb energy from any nearby ambient light, such as fluorescent lamps or sunlight. Once the source of extraneous light is removed, Pro® Glow film immediately emits a light of its own. There is no limit to the number of times this product can be recharged. When fully charged, Pro® Glow provides positive luminance for up to 10 hours.
Pro® Glow is designed for indoor safety and egress marking tapes and signage.
What's in the box?
- 1 x ProTapes Pro Glow-in-the-Dark Tape 1" x 10yds
- Technical Data
Backing
PVC Vinyl film
Luminous Compliance
PSPA Class B
Release liner
92lb Bleached Liner
Thickness
15 mils, Substrate – 0.018in (0.457mm) (PSTC 133), Pressure sensitive adhesive – 0.0015in (0.04mm) (PSTC 133), Release Liner – 0.007in (0.178mm) (PSTC 133)
Color
Light yellow/green glossy appearance
Service Temperature
High ‐ 14 days at 220°F (No visible effects, moderate shrinkage and elasticity),
Low ‐ 14 days at ‐20°F (No visible effect)
Storage Temperature
Under 70°F and 50% relative humidity.
Solvent Resistance
Water, 10% Salt Water, Bleach, Trichloroethylene, 25% Sulfuric Acid, Hydraulic Fluid, 50% Antifreeze in water, Mineral Spirits, 99% IPA
Solvent Resistance Intermittent Content Only
1% Sodium Hydroxide, Unleaded Gasoline, Diesel Fuel
Solvent Resistance Not Recommended
MEK
Luminous Values (figures below in millicandela per square meter)
DIN 67510 / ASTM 2072
Xe lamp 1000Lx/5 min
10 min 68.2 mcd/m² after 10 min
Xe lamp 1000Lx/5 min
60 min 8.76 mcd/m² after 60 min
Peel Adhesion
Stainless Steel (PSTC 101): 15 min dwell‐ 96 oz./in (105 N/100 mm), 24 hour dwell‐ 104 oz./in (115 N/100 mm)
Powder coated surfaces: 15 min dwell‐ 64 oz./in (70 N/100 mm), 24 hour dwell‐ 72 oz./in (79 N/100 mm)
Polyethylene: 15 min dwell‐ 36 oz./in (40 N/100 mm), 24 hour dwell‐ 44 oz./in (47 N/100 mm)